Program for testing motor systems HFM / PMS. When you run the program and connecting to ECM motor available reading errors. As the program reads the motor in the background, but does not display live data to the user. For information about the problems your engine to perform quality testing, and send the developer folder LOG (packed). Testing should be carried out by the following algorithm: Connect the adapter to the car and the computer. Choose the type of adapter (if using Carsoft 7.4). On cars equipped with 38 pin diagnostic connector to use a cable of the 3 wires (do not use a standard plug 38 pin). Connection (38 pin): 1 - ground (black) 3 - supply voltage (red) 4 - k-line (yellow) Increase the speed to 3000 and keep them within 30-60 seconds. Turn the ignition on and press [Connect]. Wait until you turn off the led "Wait. " Next you will see "Waiting for start-up" and then start the motor. Warm up the engine to operating temperature(>85*). Let it idle for at least 5 minutes. Increase the speed to 2000 and keep them within 30-60 seconds. Increase the speed to 2500 and keep them within 30-60 seconds. Increase the speed to 3000 and keep them within 30-60 seconds. Go to idle. In the presence of automatic transmission include "drive" and wait about a minute, turn off the "drive". If you wish to check flow to the cutoff: gently press the gas and watch that rpm is not exceeded 4500, the engine should start to work in the 4000 revolutions (up-down) and then press the gas to the floor and wait 3 seconds. Run the engine at idle a 5-10 minutes. Turn off the ignition. Pack the Logs folder and send at hfmscan@mail.ru
fipe